Submenu "Camera; Function "Pairing - Renkforce 1243795 Mode D'emploi

14. Submenu "Camera"

• As described in chapter 10, briefly push the button "MENU" (5) to call the OSD menu. Then use the con-
trol buttons "G" or "►" (9) to select the submenu "Camera" and push the button "OK" (8) to confirm.
• Use the control buttons "S" or "F" (9) to select the desired function now. Confirm the selection with
"OK" (8).
a) Function "Pairing"
Use the "Pairing" process to register the radio camera at the screen/DVR. This means that the radio cam-
era will only send its camera image to a single screen/DVR; other devices have no access to the camera
image.
The radio camera enclosed with the radio camera system is already paired with the screen/DVR ex works,
so that pairing is no longer required.
However, if you purchase additional radio cameras separately (the screen/DVR can be operated with four
radio cameras in total), they must be paired with the screen/DVR.
Each radio camera can be logged on to only one screen/DVR for reasons of safety. It therefore is
not possible to play back the signal of a radio camera on two screens/DVRs.
Only one radio camera can be logged on to each channel of the screen/DVR. If a radio camera
has already been registered at a channel, a new registration of a new radio camera will over-
write the present one.
Since only 35 seconds are available for logging on for reasons of safety, the screen/DVR and
radio camera should be in direct proximity to each other (minimum distance 1 m). Alternatively,
the login process must be performed with a second person.
Proceed as follows for teaching:
• First connect the radio camera to the voltage/current supply if you have not done so yet.
• After calling the function, use the control buttons "S" or "F" (9) to select one of the four cameras
("Camera 1" ... "Camera-4").
• Push the "OK" (8) button to start pairing.
65