Problems And Solutions - Iberspa Oasis 40 Manuel D'utilisation Et D'installation

8. PROBLEMS AND SOLUTIONS

Problem
No element is activated.
No pump or heating is activated.
FILTER
Low water flow during filtration.
Filter pump is not activated.
WATER MASSAGE
Massage pump is not activated.
Low air flow in jets.
Water comes out the Venturi jet.
AIR MASSAGE
The massage pump is not activated.
Reason
Circuit breaker on OFF position.
Operating switch in OFF position.
Obstructed or dirty filter.
Filter pump faulty.
Faulty or poorly connected contactor.
Poorly regulated thermal magnetic
breaker.
Faulty thermal magnetic breaker.
Pump selector on stop.
Signal transmission cable disconnected.
Air bulb in push button damaged.*
Faulty pump.
Faulty or poorly connected ontactor.
Poorly regulated thermal magnetic
breaker.
Faulty thermal magnetic breaker.
General massage switch on OFF.
Closed and obstructed venturis.
Incorrectly placed jet front
Signal transmission wire disconnected.
Air bulb in push button damaged.*
Faulty pump.
Faulty or poorly connected contactor.
Badly regulated thermal magnetic
breaker.
Faulty thermal magnetic breaker.
General massage switch on OFF.
Solution
Switch circuit breaker to ON.
Change operating switch to ON.
Wash filter.
Check pump / Change brushes.
Installer: Check connection wires.
Change contactor.
Adjust thermal magnetic breaker
according to motor consumption.
Change thermal magnetic breaker.
Change to manual or automatic.
Conectar el tubito* / cable.
Change bulb.*
Check pump / Change brushes.
Installer: Check connection cables.
Change contactor.
Adjust thermal magnetic breaker
according to motor consumption.
Change thermal magnetic breaker.
Set switch to ON.
Open Venturis.
Eliminate obstructions
Check jets
Connect the cable.
Change bulb.*
Check the pump / Change brushes.
Installer: Check connection wires.
Change contactor.
Adjust thermal magnetic breaker
according to motor consumption.
Change thermal magnetic breaker.
Change switch position to ON.
ENG
45