Location Requirements; Electrical Requirements; Recommended Grounding Method - Whirlpool W11224753 Instructions D'utilisation

Location Requirements

WARNING
Explosion Hazard
Keep ammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or re.
IMPORTANT: This appliance is designed for indoor, household
use only.
To ensure proper ventilation for your refrigerator, it is
recommended to allow a 1/2" (1.25 cm) space on each side.
Allow 1½" (3.81 cm) of space between overhead cabinets and
refrigerator top. Allow at least 1" (2.54 cm) between back of
cabinet and the wall (consider the condenser as back in case
is present). If your refrigerator has an ice maker, make sure you
leave extra space at the back for the water line connections.
If you are installing your refrigerator next to a fixed wall, leave
enough space on the hinge side to allow the door to swing open.
Level the refrigerator. See "Adjust the Doors" part of this manual.
NOTE: This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 55°F (13°C) to a maximum
of 110°F (43°C). The preferred room temperature range for
optimum performance, which reduces electricity usage and
provides superior cooling, is between 60°F (15°C) and 90°F
(32°C). It is recommended that you do not install the refrigerator
near a heat source, such as an oven or radiator.
1
1
/ " (1,25 cm)
1
2
4
/ " (3,81 cm)
2

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person.
Do not use a cord that shows cracks or abrasion damage along
its length or at either the plug or connector end.

Recommended Grounding Method

A 115 V 60 Hz. (Plug 1), 220-240 V 50 Hz. (Plugs 2 or 3), or
220-240 V 60 Hz. (Plug 4) AC only 10 A fused and grounded
(earthed) electrical supply is required.
Plug 1
Plug 2
It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off
by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation or cleaning,
or removing a light bulb, turn cooling off or turn the control
(Thermostat, Refrigerator or Freezer Control depending on
the model) to OFF, and then disconnect the refrigerator from
the electrical source. When you are finished, reconnect the
refrigerator to the electrical source and turn cooling on or
reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting. See "Using the
Controls" in the User Instructions, User Guide, or Use & Care
Guide.
Plug 4
Plug 3