SUOMY MrJump Instructions D'utilisation page 24

ENG
USER'S INSTRUCTIONS
Fitting – see fig. 5B
Position the internal padding of the helmet checking the direction of assembly. Fix the front tongue to its support on the polystyrene, fasten the
back stud buttons and reinsert the side tongues between the shell and the polystyrene.
After fitting the parts, make sure the internal padding was positioned correctly.
If these conditions are not verified and the internal padding was not fitted correctly, do not use the helmet and contact authorized
Suomy personnel only.
Put the cheek pads back into position (refer to paragraph CHEEK PADS).
figure 5B
22