Optional Accessories; Maintenance - PEUGEOT Energyscroll 400 Manuel D'utilisation

NOTE: Scroll saw blades generally stay sharp for 1/2 to 2 hours of cutting.
Plain-end blades
Art. N° TPI Tooth
style
96100 32 Skip
96101 25 Skip
96102 20 Skip
96103 17 Skip
96104 15 Skip
96105 13 Skip
96106 12 Reverse
skip
96107 12 Reverse
skip
96108 10 Reverse
skip
96114 8 Reverse
skip
WARNING! For your own safety, turn the switch off and remove the plug from the power source outlet before
maintaining or lubricating your scroll saw.
General maintenance
General
An occasional coat of paste wax on the work table will allow the wood being cut to glide smoothly across the work surface.
Arm Bearings
Lubricate the arm bearings after every 50 hours of use.
1. Turn the scroll saw on its side. (Fig. 8)
2. Squirt a generous amount of SAE 20 oil around the shaft end and bronze bearing.
3. Let the oil soak in overnight in this position.
4. Next day repeat the above procedures for the opposite side of the saw.

OPTIONAL ACCESSORIES

Application
3-6 mm brass, soft metal
2-6 mm wood veneer, plastic hard
rubber, pearl, etc.
2-13 mm wood veneer, wood, bone,
fibre, ivory, plastic, etc..
2-19 mm hard/soft wood, bone, horn,
plastic, etc.
25-38 mm hard/soft wood, bone,
paper, felt, plastic, etc.
25-50 mm hard/soft wood, bone,
paper, felt, plastic, etc.
6-13 mm hard/soft wood, plywood,
etc.
6-25 mm hard/soft wood, plywood,
etc.
25 mm and more, hard/soft wood,
plywood, etc.
38 mm and more, hard/soft wood,
plywood, etc.

MAINTENANCE

Pin-end blades
Art. N° TPI Tooth
style
96113 10 Regular
96110 15 Regular
96111 18 Skip
96112 25 Skip
4
Application
25-50 mm, hard/soft wood, plastic,
etc.
25-38 mm wallboard, pressed wood,
wood, felt, paper, bone, lead, etc.
2-13 mm wood, plastic, etc.
2-13 mm wood, plastic, etc.