Speed Change - Makita HR3200C Manuel D'instruction

Lighting up the lamps
For Model HR3210FCT
1
008549
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the trigger. Release the trigger to
turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.

Speed change

008538
The revolutions and blows per minute can be adjusted
just by turning the adjusting dial. The dial is marked 1
(lowest speed) to 5 (full speed).
Refer to the table below for the relationship between the
number settings on the adjusting dial and the
revolutions/blows per minute.
Number on Revolutions per
adjusting dial minute
5
4
3
2
1
008550
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
1. Lamp
1. Adjusting dial
1
Blows per minute
630 3,300
590 3,100
480 2,500
370 1,900
315 1,650
speed adjusting function may no longer work.
Changing the quick change chuck for
SDS-plus
For Model HR3210FCT
The quick change chuck for SDS-plus can be easily
exchanged for the quick change drill chuck.
Removing the quick change chuck for SDS-plus
2
1
1
2
3
008608
CAUTION:
Before removing the quick change chuck for
•
SDS-plus always remove the bit.
Hold the change cover with the thumb and the middle
finger and pull it in the direction arrow 1. With the change
cover pulled in that direction, hold the chuck cover with
the index finger. While holding the chuck cover so, pull
out the quick change chuck for SDS-plus in the direction
of arrow 2 at a stroke.
Attaching the quick change drill chuck
1
3
2
008552
Grasp the change cover and place the quick change drill
chuck on the spindle of the tool.
Make sure that the quick change drill chuck is secured by
trying to pull it several times.
Selecting the action mode
Rotation with hammering
1
2
008540
5
1. Quick change
chuck for
SDS-plus
2. Change cover
3. Chuck cover
1. Spindle
2. Quick change
drill chuck
3. Change cover
1. Lock button
2. Pointer
3. Change lever
3