Hardware Setup - Velleman DVR8H2 Guide D'installation Rapide

Enregistreur numérique h.264 à 8 canaux + vga/hdmi push video + eagle eyes
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Front panel
Press to show the multiple channel display mode.
1 – 8
Press a button to select the corresponding channel.
= SLOW + ZOOM
AUDIO
Press SLOW and ZOOM simultaneously to select live or playback audio.
= SEQ. +
P.T.Z.
Press SEQ. and
Connect a USB flash drive for video backup to the left USB port (
to the right port (
USB port
Note: Do not connect two USB mice or two USB flash drives simultaneously.
(2x)
Note: For a list of compatible USB flash drives, please refer to the appendices in the full user
manual.
Rear panel
VIDEO IN
8 video input channels to connect 8 external video sources e.g. cameras
CALL
connector for monitor specific for sequence display
AUDIO IN
4 audio input channels to connect four external audio sources, e.g. from cameras with audio
AUDIO OUT
1 audio output to connect to an audio device, e.g. a speaker (mono)
LAN port
Connect the DVR to a local network by plugging a network cable into this port.
Connect to the HDMI port of a monitor that supports HDMI video output.
HDMI
Note: You can use the MONITOR, HDMI, and VGA output ports simultaneously.
Connect to the VGA port of a monitor that supports HDMI video output.
VGA
Note: You can use the MONITOR, HDMI, and VGA output ports simultaneously.
Connect external devices such as a siren, or an alarm sensor for event notifications to your
External I/O
smart phone (push video). The push video alarm input corresponds with video input 1.
DC 19V
power supply input
power switch
Connect to a storage device that supports the eSATA interface. For example, an external
eSATA
hard disk or a disk array
6.

Hardware Setup

Installing the Hard Disk Drive (HDD)
Refer to the illustrations on page 2 of this manual.
1. Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment). The HDD must
be formatted.
2. Make sure to unplug the device from the mains before servicing and do not touch any electronic circuitry
to avoid electrostatic discharge.
3. Unscrew the 6 screws (1 on either side and 4 on the back) that hold the cover in place.
4. Lift the cover (back first).
5. Screw the mounting brackets on the HDD (screws included).
Note: The PCB must be facing upwards when mounting the HDD into the DVR.
6. Connect the SATA data cable and power supply to the HDD.
7. Screw the HDD on the bottom of the DVR housing PCB facing upwards using the included screws.
8. Close the cover (front first) and secure it with the 6 screws.
Connecting a Video Monitor
Obtain a suitable monitor (not included) and connect it to the MONITOR, HDMI, or VGA video output port on the
back of the DVR.
Note: You can use the MONITOR, HDMI, and VGA output ports simultaneously.
V. 03 – 23/10/2014
DVR8H2
simultaneously to enter or exit PTZ control mode.
).
5
); connect a USB mouse
©Velleman nv

Publicité

Table des Matières
loading

Table des Matières