Pin Connection - Velleman DVR8H2 Guide D'installation Rapide

If timer recording is enabled, the timer recording icon (
o
By default, the device is in HDD overwrite mode and the icon (
o
Playback
Make sure the control panel is not locked and press the PLAY button on the control panel or use the quick menu
bar to open the playback control panel:
A progress bar
B
control bar
C event search
Note: There must be at least 8192 images of recorded data for playback to work properly. If not, the device
will stop playback. For example, if the IPS is 30, the recording time should be at least 273 seconds
(8192 images / 30 IPS) for the playback to work properly.
• Increase or decrease the playback speed using the fast forward (
once to get 4x speed forward/backward, click twice to get 8x speed, etc. Maximum speed is 32x.
Press the pause button (
•
• Press the stop button (
Press the SLOW button once to get 1/4x speed playback, and click twice to get 1/8x speed playback.
•
Search
There are four ways to search recorded files: by record list, motion list, alarm list or by timer list.
1. To search an event, press the LIST button on the front panel (make sure the control panel is not locked).
An overview of the recorded file types (ALARM, MANUAL, MOTION, SYSTEM and FULL LIST) is shown.
2. Select the desired list and recording from the list.
3. Press ENTER to start playback.
Note: The recorded files can also be searched via the included Video Viewer software.
9. Push Video Configuration
9.1

Pin Connection

This DVR can send notifications to your mobile devices, such as iPhone, iPad, and Android mobile devices, if an
an alarm event occurs (push video). However, only certain alarm-in pins support this function.
There are several methods to connect alarm sensors for push video:
via the push video alarm-in terminal
•
via the external I/O port.
•
Push Video Alarm-In Terminal
A push video alarm-in terminal is provided on the DVR rear panel. Refer to the table below for the pin
connections that support push video and their corresponding video channels.
Alarm
Alarm 1
Alarm 2
External I/O port
Refer to the table below for the pin connections that support push video and their corresponding video
channels.
V. 03 – 23/10/2014
DVR8H2
D
E
) to pause playback.
) to return to live monitoring.
Corresponding video channel
CH1
CH2
9
) is displayed.
) is displayed.
information bar
close
) and fast rewind ( ) buttons. Click
©Velleman nv