Install Oven - Whirlpool KEBC167MSS02 Instructions D'installation

3-Wire Cable from Home Power Supply - U.S. Only
IMPORTANT: Use the 3-wire cable from home power supply
where local codes permit a 3-wire connection.
A
B
C
D
E
F
A. Cable from home power supply
B. Junction box
C. Black wires
D. White wires
E. Green (or bare) ground wire
(from oven)
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.

Install Oven

WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
1. Using 2 or people, lift oven partially into cabinet cutout using
the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside
edges.
G
H
I
F. 4-wire flexible cable from
oven
G. Red wires
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
2. Push against seal area of front frame to push oven into
cabinet until shipping feet almost contact cabinet.
A
A. Shipping foot
3. On models with shipping feet, use a Phillips screwdriver to
remove screws attaching the shipping feet.
4. Push oven completely into cabinet and center oven into
cabinet cutout.
5. Securely fasten oven to cabinet using the #8–14 x 1" screws
(2 for single oven, 4 for double oven) provided. Insert the
screws through holes in mounting rails. Do not overtighten
screws.
A
B
A. Mounting rail
B. Insert #8–14 x 1" screw.
6. On some models, the oven vent is taped to the side of the
oven. See the following instructions to install.
I Insert the vent tabs (B) into slots (A) in the oven frame.
With one #8–18 x ³⁄₈" screw (C) for each side of the vent,
I
fasten vent securely to the oven.
A. Oven frame slot
B. Vent tab
C. #8–18 x
D. Oven vent
A B
D
C
³⁄₈"
screw
7