Names And Functions Of Parts (Main Unit) - Esoteric D-05X Mode D'emploi

Names and functions of parts (main unit)

A
POWER button
Press to turn the unit on and off .
When the unit is on, the ring around the button lights blue .
When the unit is off, it is unlit .
When not using the unit, turn it off .
B
CLOCK indicator
This shows the clock synchronization status .
Lit blue
When the clock sync mode is set to CLK>OFF, the indicator
blinks while the clock signal is being detected . The indicator
stops blinking and stays lit when the signal is confirmed and
synchronization starts .
Lit green
This lights when the built-in oscillator is operating during USB
input .
C
MENU button
Use to enter setting mode (page 13) .
D
Remote control signal receiver
This receives signals from the remote control . When using the
remote control, point the end of it toward this receiver panel .
o This unit does not include a remote control .
o The dimmer of this unit can be adjusted using a remote
control included with a P-05X or other ESOTERIC product
(page 16) .
10
A B C D E F G
E
Display
This shows information about the selected input connector, for
example .
F
INPUT button
Use to change the digital input . Select a connector that has
a digital source device connected . If no digital signal is being
input, no sampling frequency will be shown to the right of the
input on the display .
o When the input source is ESLINK, the input signal format (PCM
or DSD) will be shown instead of the sampling frequency .
G
SELECT button
Use to change parameters when in setting mode .
H
OUTPUT button
Press this to cycle through analog output settings .
ATTENTION
This unit outputs audio according to the selected analog output
setting . Select the output setting for the connectors being used
to connect the amplifier (page 12) .
I
Output indicators
The indicator for the selected analog output setting lights .
H I