Basic Operation; Changing The Analog Output Setting - Esoteric D-05X Mode D'emploi

Basic operation

1
Press the POWER button to turn the unit on.
Press the POWER button in completely until it stops .
When on, the ring around the POWER button lights blue .
2
Press the INPUT button to select the source.
Each time you press the INPUT button, the active input source
changes in the following order and is shown on the display .
ESLINK DUAL
USB
Select the input source and start playback on the source device .
If no digital signal is detected, no sampling frequency will be
shown to the right of the input on the display . Confirm the con-
nections before turning connected devices on .
o When you are done using this unit, press the POWER button
to turn it off .
12
XLR1 XLR2
OPT RCA

Changing the analog output setting

Press the OUTPUT button to cycle through analog output settings .
Select the output setting for the connectors being used to connect
the amplifier .
Press the OUTPUT button to cycle through the output settings and
light the corresponding output indicator in the following order .
ESL-A XLR2
ESL-A
Output from the XLR connectors using ES-LINK Analog (ESL-A) .
o These connections use ordinary XLR cables, but the signals are
transmitted in a unique format, so it should only be used with
compatible devices .
o See page 7 for more about ESL-A .
XLR2
Output from the XLR connectors with pin 2 HOT .
XLR3
Output from the XLR connectors with pin 3 HOT .
RCA
Output from the RCA connectors .
ATTENTION
This unit will not output audio from the unselected analog audio
output connectors .
XLR3 RCA