Names And Functions Of Parts (Main Unit) - Esoteric D-02X Mode D'emploi

Names and functions of parts (main unit)

A
POWER button
Use to turn the unit on and off .
When the unit is on, the ring around this button lights blue .
When the unit is off, it is unlit .
Turn the unit off when not using it .
B
CLOCK indicator
This shows the clock synchronization status .
Lit blue
When the clock setting uses any synchronization other than
PLL (CLK>OFF), the indicator blinks blue while the clock signal is
being detected . The indicator stops blinking but stays lit when
the signal is confirmed and synchronization starts .
Lit green
This lights when the unit is operating with the built-in oscillator
during USB input .
C
MENU button
Use to enter setting mode (page 12) .
D
Remote control signal receiver
This receives signals from the remote control . When using a
remote control, point it toward this receiver when operating it .
o This unit does not include a remote control .
o The dimmer of this unit can be adjusted using a remote con-
trol included with a P-02X or other Esoteric product (page
15) .
E
Input source indicators
The indicator for the selected input connector lights .
10
A B C D E F G
F
Display
This shows information about the selected input connector, for
example .
G
INPUT button
Use to change the digital input . Select a connector that has
a digital source device connected . If no digital signal is being
input, no sampling frequency will be shown to the right of the
word "INPUT" on the display .
H
Parameter adjustment (−/+) buttons
Use to change parameters when in setting mode .
o You cannot change the volume with this unit .
H