Door And Drawer Removal - Amana ABB1921DEQ Guide D'utilisation

Installation

Door and Drawer Removal

Some installations require door/drawer removal to
transport the refrigerator to its final location.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors or drawer. Connect power only after
replacing doors or drawer.
CAUTION
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
1. Unplug power cord from power source.
2. Remove toe grille (see page 3).
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
4. Unscrew " hex head screws from
5 ⁄
16
top hinge to remove hinge and retain
all screws for later use.
5. Lift refrigerator door from center
hinge pin.
6. Remove plastic sleeve, if present.
Remove center hinge pin with a
head driver. Retain hinge pin and
plastic sleeve for later use.
7. Remove Phillips screws to remove
center hinge and retain all
screws for later use.
8. Remove bottom hinge or
stabilizing bracket with
head driver and retain screws
for later use. Lift out bottom
hinge pin (on freezer door
models).
9. See pages 4-5 for drawer removal
instructions.
5 " hex
⁄
16
" hex
3
⁄
8
Pullout Freezer Drawer
DANGER
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the
top freezer basket.
WARNING
To avoid electrical shock, which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
CAUTION
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
To Remove:
1. Pull drawer open to full extension.
2. Pull upper basket out to full extension and lift out
to remove.
3. Lift lower basket straight up and out to remove.
4. On each side rail is a
basket cradle with two snap
attachments. To release
each cradle, unlatch the
snaps by pushing them
inward, away from the side
rail system. Lift the cradles
off of the rails.
5. Remove Phillips screw from
each side of rail system (select
models).
6. Lift top of drawer front to
unhook supports from rail
system. Lift door front out to
remove.
4