Technical Specification - Metabo MIG/MAG 140 Instructions D'installation

•
Wire feed motor does not run
No power
Welding step switch in
"0" position
Torch trigger switch not
activated
Fuse blown
Motor faulty

Technical Specification

Power supply
Power input max.
Current draw max.
Mains fuse, time-lag
Open-circuit voltage
Welding current range
max. Duty cycle (40°C)
Welding steps
Wire feed rate
Electrode wire diameter
Protection class
Length x Width x Height
Weight
Current setting range
Position MIG / MAG 140 MIG / MAG 160
1 30 A
2 50 A
3 80 A
4 140 A
1.6
Check power supply
Set to a welding step
Activate torch trigger switch
Have replaced by a qualified
electrician
Have repaired by service
centre
30 A
60 A
100 A
160 A
• No wire feed
Pressure roller loose
Wire kinked at wire
feed
Groove in feed roller
worn
Electrode wire stuck to
contact tip
• Machine shuts down, overload control light
comes on
Duty cycle exceeded
Power unit faulty
MIG/MAG 140
1 x 230 V, 50/60 Hz
5,1 kVA
22 A
16 A
17,5 – 28 V
30 – 140 A
4 %
4
1,0 – 12 m/min
0,6 – 0,8 mm
IP 21
590 x 260 x 420 mm
21 kg
Increase pressure of leaf
spring with knurled thumb
screw
Adjust wire lead-in nozzle
Replace
Replace contact tip, if wire is
deformed, reduce pressure
of pressure roller
Let machine cool down,
observe duty cycle stated on
nameplate
Have repaired by service
centre.
MIG/MAG 160
1 x 230 V, 50/60 Hz
5,3 kVA
23 A
16 A
19 – 30 V
30 – 160 A
8 %
4
1,0 – 12 m/min
0,6 – 0,8 mm
IP 21
590 x 260 x 420 mm
26,5 kg
MIG/MAG 140/160