Driosec iontodry Mode D'emploi page 34

4NS Technologies declines all responsibility for any damages or
®
consequences resulting from unauthorized attempts to open,
modify, or repair the device. These actions may only be carried out
by repair services officially authorized by the manufacturer.
iontodry does not require calibration. All units are systematically
®
tested and validated prior to distribution. Their characteristics do not
vary under normal conditions.
Nonetheless, as iontodry is a high-quality electrical instrument,
®
its lifespan depends on the use that is made of it and the care and
maintenance it receives during its lifetime. If your device contains
parts that seem worn or defective, please contact the technical
service centre for an upgrade (www.driosec.com). The battery
replacement will always be undertaken by specialized staff of 4NS
Technologies at its physical facilities.
®
The user should change iontodry foam pads once spoiled
®
(approximately 6 months). For a perfect functioning of the device,
it is recommended to use the foam pads provided by the manufacturer.
EN
In case of using any other type of pads, please make sure they
34
accomplish the biocompatibility requirements.
The user can also change the aluminum electrodes once deteriorated
(approximately 10 months). For a perfect functioning of the device, it
is recommended to use the aluminum electrodes provided by the
manufacturer. In case of using any other type of electrodes, it will be
at the user's own risk and responsibility.
The user can also replace the connection cables (Jack and USB), if
needed. It is advised to use all the accessories supplied by Driosec to
®
ensure a good operation of the device. These parts can be purchased
at the manufacturer's website.
Please refer to section III.5 Problems and solutions in order to change
the battery, the Jack cables, the USB cable , the aluminum electrodes
or the foam pads.