Polar DN492 Mode D'emploi page 6

UK
Starting a cycle
Push and release the START/STOP
Temporarily stopping the Running cycle
1. Press and release the
The compressor and the fan will be stopped and the flashing message "STB" will be displayed.
2.
3. To restart the cycle press and release the
interrupted.
4. If the cycle is not manually restarted the Chiller will automatically restart after 20 minutes.
How to stop a cycle
Press the START/STOP
When a Cycle is Running
Display Temperatures
The upper display shows the temperature of the thermostat probe. The bottom display shows the temperature of an
insert probe, ip1.
ip2 & ip3 are not included, if displayed press the down key until ip1 is displayed.
Cycles / Phases
Every programmable cycle Cy1, Cy2, Cy3 or Cy4 can be divided into up to 3 phases usually called:
1. hard chill
2. soft chill
3. freezing cycle
Each cycle is controlled by the probe temperature by default.
Pushing the up key the running phase is displayed.
Telephone Helpline: 0845 146 2887 (United Kingdom)
button (2). The correspondent yellow LED is switched on.
key.
key, the cycle will restart from the same point at which it was
button (2) until the yellow LED switches off
6