Polar DN492 Mode D'emploi page 5

Telephone Helpline: 0845 146 2887 (United Kingdom)
LED
① ② ③ ④
H
① ② ③ ④
H
AUX –AUX2
Setting the Time / Date
1. Hold the DOWN key (1) until the Min label is displayed.
2. Use the UP and DOWN KEY to browse the parameters.
MIN = Minutes
HOU = Hours
DAY = Day
MON = Month
YEA = Year
TIM = 12/24 Hr Clock
3. To Modify push the SET button and then the UP and DOWN keys.
4. To Confirm: push the SET button.
5. To exit the menu: Push together SET + UP keys or wait 5 sec.
Selecting a Cycle
Push the to move among the cycles C1, C2, C3, C4 and the holding cycle. The related symbol on the
display will be lighted and the cycle will be selected.
Note: to pass from a cycle to another one simply push the
Cycles are pre-set with the following values:
Cy1: for fast chilling and conservation of foods (hard +soft chill).
Cy2: for chilling and fast freezing of foods (hard +soft + freezing cycle).
Cy3: for direct fast freezing (only fast freezing cycle)
Cy4: for direct fast freezing without holding (hard chill + freezing cycle)
HLd: hold mode function
dEF: for starting a manual defrost
MODE
ON - Compressor enabled
- Programming Phase (flashing with LED
Flashing
- Anti-short cycle delay enabled
- Fans enabled
ON
- Programming Phase (flashing with LED
Flashing
- Activation delay active
ON - Defrost active
- Drip time active
Flashing
- Freezing cycle 1, 2, 3, 4 or hold mode active
ON
Flashing - Instrument temporarily stop
- Alarm signal
ON
ON - Aux or Aux2 enabled
ACTION
key when the controller is in stand–by mode.
UK
)
)
5