Brew Monk 057.700.30 Manuel D'utilisation page 28

EN - Instruction Manual Brew Monk
• The blue valve, on the circulation pipe, in horizontal position closes the ball valve. The blue
valve, on the circulation pipe, in vertical position opens the ball valve.
• Switch off the pump when you close the blue valve for longer than 5 seconds.
• Always close the blue valve and switch off the pump before removing the curved pipe (11).
• Do not run the pump during wort boiling.
• It is not recommended to use the pump for pumping the wort after cooling, as there is no
filter on the pump inlet. This can cause brew debris to enter the pump, potentially blocking
and damaging the system.
2.2 Bazooka Filter Assembly
Attach the bazooka filter (12) on the male thread inside the Brew Monk using the connector and
screw the bazooka filter on (see pictures below).
2.3 Overflow Pipe Assembly
C
2.3.1 Malt Pipe Assembly Outside the Brew Monk
Step 1
28
A
D E
1 x top malt screen (1 centre
A
hole + 2 small holes)
1 x reinforced bottom malt
B
screen (1 centre hole)
C
2 x handle
B
D
1 x nut
E
1 x telescopic overflow pipe
Place male thread
connector (H)
through bottom
malt screen (B)
and attach with
1 double female
thread connector
(F).