Door Closing; Beverage Center Use; Normal Sounds; Using The Control - Whirlpool WBC127BLS Guide D'utilisation Et D'entretien

Door Closing

Door Closing
Your beverage center has four leveling legs. If your beverage
center seems unsteady or you want the door to close more easily,
adjust the beverage center's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
2. Move the beverage center into its final location.
3. Turn the leveling legs to the right to lower the beverage center
or turn the leveling legs to the left to raise it. It may take
several turns of the leveling legs to adjust the tilt of the
beverage center.
NOTE: Having someone push against the top of the beverage
center takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door and check to make sure that it closes as easily
as you like. If not, tilt the beverage center slightly more to the
rear by turning both front leveling screws to the right. It may
take several more turns, and you should turn both leveling
legs the same amount.
6

BEVERAGE CENTER USE

Normal Sounds

Your new beverage center may make sounds that your old one
didn't make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your beverage center is designed to run more efficiently to
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your beverage center to run longer than your
old one. You may also hear a pulsating or high-pitched sound
from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the beverage center.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your beverage center.
You may hear water running into the drain pan when the
beverage center is defrosting.
You may hear clicking sounds when the beverage center
starts or stops running.

Using the Control

The beverage center has an electronic control panel that allows
total cabinet temperature control. It also offers the option of
displaying and setting the temperature in Fahrenheit or Celcius.
Adjusting Controls
To adjust the temperature on the beverage center, press the up or
down arrow once to enter the SET mode. The temperature
display will flash to let you know that the temperature can be
adjusted.
To make the beverage center cooler, press the down button until
the desired temperture is reached.
To make the beverage center less cool, press the up button until
the desired temperature is reached.
Each depression of the up or down arrow will adjust the
temperature 1 degree. The temperature can be set between 43°F
and 57°F (6°C and 14°C).
NOTE: After the beverage center has been turned off, wait 3 to
5 minutes before restarting.