Whirlpool WBC127BLS Guide D'utilisation Et D'entretien page 5

Reverse Door Swing (optional)
1. Remove the upper hinge pin from the right side of the cabinet
and reinstall it on the left side. See Graphic 2.
2. Remove the plastic cap from the top left side of the door
frame and reinstall it on the top right side of the door frame, in
the previous pin location. See Graphic 1.
3. Reposition the door on the cabinet and push up until the top
hinge pin is inserterted into the top of the door.
4. Remove the bottom left leveling leg and transfer it to the right
side. See Graphic 5.
5. Remove the two retaining screws on the bottom left side of
the cabinet and reinstall them on the right side in the former
lower hinge assembly screw positions. See Graphic 6.
6. With the door closed, reinstall the lower hinge assembly on
the left side of the beverage center. See Graphic 3.
7. Reinstall leveling leg. See Graphic 4.
Final Steps
1. Stand the the beverage center upright and verify the door
aligment and proper seal against the cabinet.
2. Let stand upright for 60 minutes.
A
A. Plastic Cap
A. Screw Washers
B. Spacers
C. Retaining Screws
1
6
A
B
C
5
Leveling Leg
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug in beverage center or reconnect power.
4
Leveling Leg
for Bottom Hinge
Top Hinge
A
A. Top Hinge Pin
Bottom Hinge
A
B
C
D
E
A. Hinge Washer
B. Bottom Hinge Pin
C. Screw Washers
D. Spacers
E. Hinge Screws
2
3
5