Marmitek CM15Pro Guide D'installation Rapide page 7

5. Turn on your PC.
6. Disable or turn off your antivirus software before you install the software as some
antivirus programs interfere with the installation.
7. Plug the USB cable into your PC (Wait for connecting the other end of the USB cable
to the CM15Pro till the software tells you to.)
8. Insert the ActiveHomePro CD in your CD-ROM drive. After a few seconds the instal-
lation should start and the AHP Setup windows should appear on your PC screen.
The software installation process will install the driver for your CM15Pro and the
main AHP Application. If the installer does not start auto-
matically, open your CD drive using Explorer and double-
click on Setup_ahp_eu_xxx.exe. (where xxx is the version
of the software) Follow the installer prompts which
appear on your screen.
9. Connect the other end of the USB cable to the CM15Pro
when the software tells you to.
10. After the installation is complete, please review the Help
file in the application for further assistance.
11. You can now turn on your anti-virus program again.
OPERATION
Using Marmitek ActiveHomePro
To familiarize you with the AHP software, we will explain shortly how to operate a lamp
and appliance module and what you can do with macros and timers.
All you need to do is run your Marmitek AHP software — your software controls the
Interface. Use the entry in your Windows Start Menu to open the program.
When the AHP opens for the first time, the AHP Intro Wizard will start to make you
familiar with the software.
When you have finished the AHP Intro Wizard, it has loaded a standard profile and will
show a graphical representation of a Lamp Module and Appliance Module as well as 2
sample Macros.
You can always start the AHP Intro Wizard again by going to Help, Run Intro
Wizard....
The Lamp Module has been named "My Lamp Module" and the Appliance Module is
named "My Appliance."
"My Lamp Module" is already set to address A1 (HouseCode A, Unit Code 1 located on
the bottom center of the "on screen" module). This should correspond to the setting of
the physical Lamp Module that you will install (sold separately).
The "My Appliance" on screen module is set to HouseCode A and Unit Code 2 to cor-
CM15Pro ™ + ActiveHome Pro ™ 7