BREIL 6U50 Mode D'emploi page 20

2) Timer Set/Start/Stop
Timer I and Timer II functions are the same. Refer to the specifications for further
details of Timer I operations.
3) Time up and Auto chronograph features (Timer II only)
At the end of a timing session, an end-of-session confirmation beep sounds for 2
•
seconds, the watch switches to the chronograph mode and measurement begins.
(Auto chronograph function).
A time up warning beep sounds once at the following intervals: before the set time is
•
up 5, 3, 1 minutes and every 10 seconds from 50 to 10, 5, 4, 3, 2, 1.
Start
IMPORTANT
Changing modes when Timer II is active will cancel the timing session.
The timer settings remain unchanged.
16
Chronograph start
Time up
Time up beep (2 seconds)
See the chronograph
section for details of the
chronograph features.