Operating - Medisana MC 825 Mode D'emploi

GB

3 Operating

down to the base of the backrest. Once the heads reach this point, the direction of rotation is reversed
again and then travel up the back again.
Upper Back button
The Shiatsu massage heads
reversal of the direction of rotation takes place when the respective end positions are reached.
Lower Back button
The Shiatsu massage heads
reversal of the direction of rotation takes place when the respective end positions are reached.
BACK HEAT button
The heat function can be activated at any time with the shiatsu massage, during which the akupressur
Massage can also be activated. Press the BACK HEAT button
the control unit and the massage heads light up red. The heat is radiated through the massage
. Press the button
heads
LED and the red light of the massage heads go out.
AIR BACK button
An acupressure massage in the waist and thigh area can be added to the Shiatsu massage function at
any time by pressing buttons
Switch on the device by pressing ON/OFF button
Press the button for the acupressure massage

/ inflate. They begin with a gentle massage. Pressing the Intensity button
of the massage (medium intensity massage). The LED 2 lights up. Pressing the Intensity button
again activates the strongest massage setting (highest intensity massage). The LED 3 lights up. Once
/ is pressed the acupressure massage switches off and the LED goes out.
button
Do not use the massage device for longer than 15 minutes and then allow it
to cool. Using the device for longer can overstimulate the muscles and cause
tension instead of relaxation.
The massage can be finished at any time by pressing the ON/OFF
After each use, switch the device off using the ON/OFF button
the plug
3.1 To switch off the device
ON/OFF button
Press the
down to the "Park" position. When this position is reached, the LED extinguishes. If you press the
ON/OFF button
shoulder, waist and seat just stop immediately, including heat function. First the massage heads in the
back travel downwards to the "Park" position. The LED flashes meanwhile and then extinguishes.
18
(upper back)
travel up and down the upper half of the back in a circular motion. The

(lower back)
travel up and down the lower half of the back in a circular motion. The
again or stop the Shiatsu massage, to de-activate the heat function; the
/ AIR SEAT button
/ . The acupressure massage can also be used separately.
from the mains socket. Always store control unit in its bag
power LED begins
. The
while one of the massage functions is switched on, the massages in neck/
to activate the function; the LED on
(acupressure buttons)
.
/ . The Intensity LED lights up and both air cushions
to flash and the massage heads travel back
increases the intensity
button.
and remove
.