PIXO C-USB Mode D'emploi page 10

LED functions
CHARGE grün POWER rot
Off
Flashing
On
Off
Flashing
Safety Notes
The battery pack and the charger become warm when charging. This is not a
technical defect. Batteries must be charged only under supervision. Remove
the battery pack if it is fully charged. Handle your charger carefully. Do not
subject your charger to physical shocks, high or low temperature, humidity,
dirt, dust or liquids. Keep the unit away from children. Use only in dry rooms
Handling precautions for batteries
Charge new batteries before first use. New NiMH / NiCd batteries must be
used (charged and discharged) several times to reach full capacity. Batteries
must be removed from the device, if you do not use it for a long time. Li-Ion
batteries must be stored in a discharged state, but not below < 3V / < 6V
(deep-discharged state). NiMH / NiCd must be stored in a fully charged state.
Charge and discharge the battery every 6 months. Batteries are consumable
parts and must be replaced at low capacity. Handle your battery carefully.
Do not subject your battery to physical shocks, high or low temperatures,
humidity, dirt, dust or liquids. Do not short circuit, solder, disassemble or
put in fire. Batteries may become warm when charging and discharging. This
is not a technical defect. Take care when disposing of the batteries. In some
countries there are special requirements for battery disposal. Keep batteries
away from children.
Technical specifications are subject to be changed without prior notice.
All trademarks are property of their respective owners.
Off No or faulty power source.
On Charge process is going on.
On Battery fully charged.
On Main power from USB interface, power supply or car
cigarette lighter plug ok. No battery pack inserted. Faulty
contact. Wrong or faulty battery pack.
Flashing Charge process was stopped by 10 hours AA/AAA safety
timer. Battery pack could not be fully charged. Battery pack
faulty. Process error. Remove batteries and try again.