Publicité
Les langues disponibles
Les langues disponibles
With the help of another person take the heater and then spend all wire and plug from
inside the base.
Insert the heater into the top tube and secure with the two screws provided (Detail 1)
Pull the power supply wire through and fix it to the bottom of the base by the two fasteners
and screws (Detail 2).
4.
Use of equipment
Make sure the power supply corresponds to the details shown on the nameplate:
230 V ~ 50Hz.
Connect the plug into the wall socket.
Using the light switches (Detail 1), you can turn the lamps on and/or turn off manually.
5.
Maintenance
Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
This product does not require special maintenance. It needs to be cleaned periodically to
prevent accumulation of dust on the lamps, as this may cause overheating of the heater.
Clean the lamp with a brush and the body of the product with a damp cloth.
The replacement of the lamps must be performed by qualified personnel, so contact the
Official Service network of S&P, to ensure adequate technical assistence.
Do not immerse the device or spray with water.
If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
6.
Removal from service and recycling
EU regulations and our commitment to future generations oblige us to recycle used
materials; please remember to dispose of all unwanted packaging materials at the
appropriate recycling points, and to drop off obsolete equipment at the nearest waste
management point
Switch
Nº Lamps
●
1
●●
1
● + ●●
2
9
Power
1200W
1800W
3000W
Publicité
