Publicité
Les langues disponibles
Les langues disponibles
The means of disconnection must be incorporated in the fixed installation, for
disconnection from the power supply the switch must have a contact separation of at least
3 mm at all poles, so as to allow a complete disconnection in accordance with the
conditions over Voltage category III.
Never leave your home with the product still running. If you do go out make sure that the
switch is disconnected.
Do not move or shift the device when it is connected to the electrical supply.
The device has high surface temperatures, which must not be touched, even after it has
been switched off.
Never cover the product, even after disconnecting.
Do not allow animals or children to play with or touch the product.
Warning! When working the air outlet grille can get very hot.
This product must not be used by people (including children) with limited physical,
sensorial, or mental capacity or with inadequate experience or knowledge that are not
supervised by a person that is responsible for their safety or until they have been
adequately trained. Children must be supervised to ensure that they do not play with the
product.
Do not clean the product while it is working and do not immerse it in water.
Do not handle the heater with wet hands.
Do not coil the power cable around or on top of the product while it is working.
Prevent the power cable from touching the body of the device during is working.
If the cable gets damaged and has to be changed, do not do this yourself – take the
equipment to an authorised repair centre because the work must be done by specialist
personnel to avoid any risk of damage.
Do not use the heater as a clothes or towel dryer.
Do not hang anything on the device.
Once assembled, choose the place of use, making sure the base of the heater is located at
least 1.80 m above the ground.
3.
Mounting (Figure 1)
Read the safety warnings before starting to mount the product.
We recommend a minimum of 2 people for mounting the base.
Do not connect the device to the electrical supply until it is fully mounted.
Screw the bottom metal tube (E) to the base (F).
Screw the middle metal tube (D) to the bottom tube (E).
Screw the upper metal tube (C) to the rest of the set. Make sure the two holes are at the
top to ensure the heater can be locked in place (Detail 1).
8
Publicité
