JB Systems AX700 Mode D'emploi page 2

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
ENGLISH
GENERAL
AX700 Input Section is constructed by J-type fet tube and advanced
OP Circuit, together with DC Servo power. AX700 has a high
impedance, low noise and large range of frequency response.
AX700 has a protection function as follows:
Power ON/OFF transmission, prevents against surges.
DC protection at speaker output: the amplifier will automatically cut
off the link with the speakers when the amplifier has a defect.
Thermal cut off protection: the amplifier will automatically cut off the
link with the speakers when the temperature is more than 85°.
Short circuit current limited protection.
PRECAUTIONS
Don't put anything on top of the amplifier.
Always use a power source of adequate capacity.
Wait several minutes when turning the power amplifier ON/OFF
continiously.
Don't let the ventilation holes on the body of the amplifier get
obstructed in any way.
Input level can be adjusted via the gain switch of each channel.
Output can be used with phone Jack or speakon.
Don't obstruct the cooling system on the rear panel.
Before cleaning the amplifier, turn it off and cut off the power supply.
Wipe it with a dry cloth. Don't use solvent or a chemical cloth.
If there is a defect, disconnect the power cord and contact your
dealer.
AX700
2

Publicité

Table des Matières
loading

Table des Matières