Ibo-Cop2 - Babboe GWA System Manuel D'utilisation

• Data sheet
Model

ibo-COP2

Product Description Battery health diagnostic and cell optimization kit
DC Rating (max) 42VDC (input) & 37.8VDC (output)
Switching Current Up to 4A
AC Power Resource Equipped with a 2 pin AC power cord
1x DC input port for the connection with GWA authorized lithium ion charger
Connectors
1x MX216 connector set for the connection with GWA authorized lithium ion
battery pack
Operating Temperature
0°C to 45°C
Storage Temperature & +0°C to 40°C /
humidity humidity <= 65% at 25oC
CE/FCC
Standards Compliance
EN15194:2017 compliance
NOTICE
The COP2 doesn't work by itself, it must work together with a GWA lithium ion battery pack and GWA lithium ion
charger in order to connect well with each other without bending any pins. Any bent pin can cause electrical faults.
• Front panel
ERROR LED
x 1 (Red)
POWER LED Battery Capacity
x 1 (Green) LED x 4 (Green)
60
COP LED DC Input Port x 1
x 1 (Yellow) - Connecting to charger Via DC jack
CAL LED CAL Push
# of LEDs = 8 pcs
x 1 (White) Button x 1
# of CAL Push Button = 1 pcs
# of DC Input Port = 1 pcs
# of DC Output Port = 1 pcs
• Charging procedure
Step 1:
First, connect the ibo-COP2 box to the charger via a round DC jack.
Step 2:
Second, the charger can now plug into a AC 220V wall outlet. The COP2 will then enter a self-diagnostic
procedure for 5 seconds, where all 8 LEDs will light up and flash from LEFT to RIGHT one after another.
Step 3:
Third, connect the COP2 to the battery packs. If no error is detected, the power LED on the front panel will show a
steady green and the battery capacity LED will display the battery pack's remaining capacity.
(rear panel)
61