Use Of The Cookie Attachment; Faults And Troubleshooting; Cleaning - Beem PANTHER LW-6108 Mode D'emploi

6.7

Use of the cookie attachment

T+U

Faults and troubleshooting

7.
Faulty function
Drive motor not
running
Appliance switches
off abruptly
Fuse blows

Cleaning

8.
WARNING
Danger of injury
Always pull out the mains plug before cleaning.
DANGER
Danger of death from electric shock
Never immerse the appliance in water or other fluids.
CAUTION
Material damage
Never use aggressive or abrasive cleaning agents.
 Switch the appliance off and unplug.
 When disassembled, the grinder-housing (not the motor unit!) can be rinsed.
 For disassembling push the release button button (D) and remove the grinder housing
from the motor unit while turning slightly.
 Rinse all accessories with lukewarm water and rinsing agent.
 Therefore please put all parts of the mincing unit A to C and J to U for at least 10
Minutes in warm water.
 Then clean all parts with a brush and rinsing agent. Clean thoroughly the inside of
grinder housing (C) and all parts A, B and J to U especially also around the plastic
gear (V) and the inside of screw ring (O).
BEEM – Elements of Lifestyle
Remove the srew ring (O) and fit the cookie attachment
without slider to the grinding disk. Note that the insert
at the side of the cookie attachment must fit onto the
insert of the grinding disk. Attach the screw ring to the
grinder housing again and tighten by turning clockwise.
Possible reason
Mains plug not plugged in
No electricity supply
Appliance overheated
Appliance overheated
Appliance is faulty
Too many appliances connected
Remedy
Connect the appliance to the
mains
Check the fuse/plug
Pull out the mains plug and
wait at least 60 minutes
Pull out the mains plug and
wait at least 60 minutes
Inform the after-sales service
Reduce number of appliances
using the circuit
21/60