Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use
6.
6.1
Assembly of meat grinder
Before inserting the plug into the power socket, make sure that the appliance is switched
off.
1. After removing the screw ring (O) insert knife (M) and the desired grinding disk (J, K,
N) into the grinder-housing (C).
2. Please note that the parts must be fitted into the housing in the following order:
worm shaft (L) - knife (M) - disk (J, K, N).
3. The sharp blade of the knife (M) must always face towards the grinding disk (see
figure below).
4. Tighten the screw ring (O) by turning clockwise.
5. Insert the grinder-housing into the motor unit at an angle of 45°.
6. Then turn the grinder housing counter clockwise until it reaches a vertical position
and clicks into place.
7. Fit the tray into the inlet of the grinder housing.
6.2
To use the meat grinder
Switch on the appliance. For pushing food in the grinder housing in order to avoid injuries
always use the pusher. Excessive filling does not speed up the mincing process!
Please note that excess fat has to be trimmed of the meat and the meat has to
be cut into cubes before putting into the grinder housing.
6.3
Hints for usage
The motor is protected against overload by a temperature-controlled cutoff switch and
switches off automatically if overloaded. In this case let cool down the appliance for
about 60 minutes.
NOTE: If overloading has occured, turn off the appliance and unplug. Check the
cause of disturbance and eliminate it. After 60 minutes plug in again. The
appliance is ready for use.
The reverse button (G) is to be used if the worm shaft gets stuck, because of unproperly
minced meat. In this case push the reverse button for about 2-3 seconds, just to allow
the worm shaft to free itself. Remove the meat that has blocked the mincing process.
The appliance is now ready for further use.
Note: the reverse button must only be used for max. 10 seconds otherwise the
motor will be damaged. In this case the manufacturer assumes no liability.
BEEM – Elements of Lifestyle
19/60
Publicité
Table des Matières
