Télécharger Imprimer la page

Tecfrigo PRIMERA Installation Et Mode D'emploi page 5

Publicité

Les langues disponibles

Les langues disponibles

Congratulations with your new Ice Cream Conservator. We feel certain that it will be very
useful to you for many years ahead. Many years of experience have lead to the
development of a wide range of Ice Cream Conservators merchandisers to meet the
demand in the world of cooling and freezing equipment anywhere. All our Conservators,
freezers and coolers are manufactured taking the environment into consideration to the
highest possible degree. We use only 100% CFC-free insulation foam and refrigerant,
still maintaining an uncompromising attitude to the freezing and cooling performance.
Our ice cream conservators don't contain any form for asbestos and the oil in the
compressor does not contain PCB.All the material used is in accordance with the RoHS,
2002/95/EC Directive. Our model range of Ice Cream Conservators with sliding glass lids
has been specially designed to store ice creams and frozen foods, considering
performance and safety according to the International Standards. To obtain optimal
benefit from your Ice Cream Conservator, please read the following instructions
thoroughly and act accordingly. All service on the R134a / R404a refrigeration system
must only be done by a skilled service engineer.
Installation
*
Check whether the conservator has been damaged during transportation. If yes,
contact your
dealer immediately.
*
Place the conservator on a plane surface min. 100mm away from each wall. Do
not place the
conservator close to strongly heat-emitting sources, and do not expose it to direct
sunlight.
*
The conservator has been cleaned from the factory but we recommend you to
clean it again using a solution of one teaspoon of sodium bicarbonate added to 0.5 litres
warm water. Do not clean the glass lid with powder or scrabbling detergents.
Electrical connection
This appliance is equipped with a non-rewire able plug. If the plug does not fit with the
socket or the supply cord is damaged, it must be replaced by manufacturer, its service
agent or similarly qualified people in order to avoid hazards.
WARNING:
This appliance must be earthed!
Plug the mains lead into a socket which will supply the voltage indicated on the rating
plate. The working voltage of the appliances is 230V/50Hz.Variations in the mains voltage
of +/-10% are allowed, but major variations will reduce the life time of the compressor.
Never use too long extension cable because it can result in a voltage drop and give poor
starting conditions for the compressor. We recommend min. 1.5mm² wires for a 10m
extension cables. If there is any doubt about the correctness of the installation, we
recommend that it should be checked by a qualified electrician.
Control panel.
As a standard the Ice Cream Conservator is not equipped with a control panel to keep
the front of the cabinet free for the customers branding. The thermostat is located behind
the louvered plate, which covers the access to the compressor compartment at the end of
the cabinet. The louvered plate is fixed with 4 screws, which have to be taken away by a
screw driver if you want to adjust the thermostat. The thermostat is located at the left-
hand side.
English
5

Publicité

loading