Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
20. Clock adjustment
Use the
and
keys to adjust the clock.
The time increases (or decreases) one minute each time
the key is pressed.
If one of the keys (
or
more than 10 seconds, the minutes setting stops and the
hours setting increases (or decreases).
During the time setting phase, the seconds remain at "00".
21. How to access the programming mode
N.B. ONLY if the item "Customer Progr." is set on
"YES" and the item "Program. block" is set on
"NO".
To access programming press the
message will appear on the display:
CUSTOMER PROG.
KEY MENU
WASHING
DATA MENU
CUSTOMER
Use the
and
keys to position the cursor (black line)
on the desired line, then press the
Always use the
and
this point there are two possibilities:
1) con rm the changes made by pressing the
2) exit the menu and leave the settings unchanged by
pressing the
key.
) is pressed and held down for
key the following
key.
keys to change the setting at
key
20
September
wednesday
Note: When modifying data, the cursor changes to "
", or a slide bar with maximum and minimum
settings will appear:
Water dose
0000
-
30 EN
2017
15:18:12
0090
1999
+
Publicité
Chapitres
Table des Matières
