Alecto DVC-215IP Mode D'emploi page 28

3. TO MOUNT THE CAMERA ON A FIXED SPOT.
The camera can be mounted onto a fixed wall.
Attention: Make sure the camera is already registered to the Wi-Fi network.
When the camera is installed and then connected to the mains, it'll re-establish
the connection with the network. If a wired network connection can be used after
mounting the camera, this will not be necessary.
Determine beforehand the most suitable location for the camera. Now check
whether this location is within range of your Wi-Fi network. To do this, briefly
connect the camera to the mains and check whether a connection is established.
When everything is working properly, drill a hole in the wall for leading the cables
through. Mount the camera onto the wall using 3 screws and, if required, plugs.
At the other side of the wall on the inside, connect the adaptor and insert it into
a wall socket. The camera will now start functioning. Now aim the camera at the
desired object by somewhat loosening the adjusting screw on the foot of the
camera, aiming it and fastening the screw again. The camera is now ready for
use.
TIP: If you consider the hole for in the wall to be too large, you may first mount a
small box (not included) onto the wall for tucking away the cables and then screw
the camera onto the box. You may also install the box next to it. Through the hole
in the wall, now only the adaptor cable must be arranged allowing for a smaller
hole.
28