Futurelight PHS-200 Mode D'emploi page 35

5. Press [EXIT/DN] return to main menu.
Run
- Run the internal program
With this function, you can run the internal program. You can set the number of steps under Cont. You can
edit the individual scenes under Edit.
8. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
9. Select "RUN" by pressing [UP] button.
10. Press [ENTER], the display shows "ON" or "OFF".
11. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
12. Press [ENTER] to confirm.
13. Press the Exit/Down-button in order to return to the main menu.
14. If you selected "ON", the projector will run the built-in program.
- Lamp adjustement
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "LADJ" by pressing [UP] button.
3. Press [ENTER], the display shows "ON" or "OFF".
4. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
Disp
- Display the DMX 512 value of each channel
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "DISP" by pressing [UP] button.
3. Press [ENTER], the display shows "DP-X", "X" stands for the channel No.
4. Press [UP] to choose the desired channel, for example: when you choose "DP-E", it displays the DMX
value of the 14th channel.
5. Press [ENTER] or [EXIT/DN] to exit.
6. The display shows „dXXX", „X" stands for the DMX-value.
rDis
- Reverse the display 180°
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "rDIS" by pressing [UP] button.
3. Press [ENTER], the display shows "ON" or "OFF".
4. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't; the display will change
180°.
5. Press [ENTER] or [EXIT/DN] to exit.
rpan
- Pan Reverse
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "rPAN" by pressing [UP] button.
3. Press [ENTER], the display shows "ON" or "OFF".
4. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
5. Press [ENTER] or [EXIT/DN] to exit.
rtil
- Tilt Reverse
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "rTIL" by pressing [UP] button.
3. Press [ENTER], the display shows "ON" or "OFF".
4. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
5. Press [ENTER] or [EXIT/DN] to exit.
Rest
- Reset
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Select "rEST" by pressing [UP] button.
3. Press [ENTER], the display shows "ON" or "OFF".
4. Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
5. Press [ENTER] or [EXIT/DN] to exit.
35/75 51838165X87NXS_V_1_1.DOC