Important Instructions; Technical Data; Additional Safety Instructions; Sound And Vibration - ALPHA-TOOLS A-FS 1800 UG Mode D'emploi D'origine

Anleitung_A_FS_1800_UG_SPK7:_

4. Important instructions

4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations (see
supplementary sheet) before using for the first time.

4.2. Additional safety instructions

Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Never use segmented cutting wheels.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
05.08.2009 9:58 Uhr Seite 13

5. Technical data

Motor rating
Motor speed
AC motor
Insulation material class
Protection type
Table size
Cut length
Jolly length
Max. workpiece thickness 90°
Max. workpiece thickness 45°
Diamond wheel
Weight

Sound and vibration

Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.

6. Before using for the first time

The machine must be set up so that it stands
firmly, i.e. it must be securely screwed to a work
bench, the base frame supplied in delivery, or
similar.
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
GB
600 W
3000 rpm
230 V ~ 50 Hz
Class B
IP54
500 x 385 mm
430 mm
430 mm
25 mm
17 mm
Ø 180 x Ø 25.4
28 kg
94 dB(A)
3 dB
107 dB(A)
3 dB
13