ECOVACS ROBOTICS Deebot R95 Mode D'emploi page 7

39. Place the cords from other appliances out of the area to be cleaned.
40. Do not operate the vacuum in a room that has lit candles on
furniture that the vacuum may accidentally hit or bump into.
41. Do not allow children to sit on the vacuum.
42. Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a
risk of fire when used with another battery pack.
43. Use appliances only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire.
44. The robot contains batteries that are only replaceable by skilled
persons. To replace the robot's battery, please contact Customer
Service.
45. If the robot will not be used for a long time, power OFF the robot
for storage and unplug the Charging Dock.
SAVE THESE INSTRUCTIONS
For Household Use Only
This Device Complies with DHHS Radiation Rules, 21CFR Chapter 1, Subchapter J.
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended.
To disable Wi-Fi module on DEEBOT, power the robot ON. Place the robot on the Charging Dock
making sure the Charging Contacts on DEEBOT and the Charging Dock Pins make a connection.
Press and hold the AUTO Mode Button on the robot for 20 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, power the robot OFF and then power ON. The Wi-Fi module
is turned on when DEEBOT is restarted.
1. Important Safety Instructions
.
5
EN