Factory Default Settings - Fracarro D-Matrix 8T Instructions D'emploi

Once one or more configuration files have been saved on the PC or a USB drive, the desired configuration
file can be loaded into the D-MATRIX 8T: from the OPERATIONS -> LOAD CONFIGURATION -> FROM FILE /
USB DRIVE menu you can access the configuration reset/load pages of the previously saved configuration,
respectively from a PC file (fig. 16) or from a USB drive (fig. 17).
Select the saved configuration file and confirm the download by clicking on "Upload configuration".
From the menu OPERATIONS -> FACTORY DEFAULT menu, it's possibile to factory default the headend set-
tings.
After clicking the "Factory Default" key, a new window will be open. It's possible to decide if the factory default
restore procedure must affect the ethernet network settings. Click NO and the factory settings won't be mo-
dified and it will be possible to connect to D-MATRIX 8T as set before with the IP address that was set before.
Click YES if you want the network parameters are restored to the factory configurations, consequently the
default parameters will be the following:
• DHCP DISABLED
• IP 192.168.0.2
• PORTA 80
• NETMASK 255.255.255.0
• GATEWAY 192.168.0.1
• DNS 0.0.0.0
5.4 UPLOAD THE CONFIGURATION
Fig.16

5.5 FACTORY DEFAULT SETTINGS

Operating instructions
Fig. 18
53
Fig. 17