Fracarro D-Matrix 8T Instructions D'emploi page 44

Using the mouse, click on the label of one of the 8 inputs or use the menu at the top CONFIGURATION ->
INPUT -> INPUT 1 / INPUT 2 / INPUT 3 / INPUT 4 / INPUT 5 / INPUT 6 / INPUT 7 and INPUT8 to enter the fol-
lowing window:
This page shows all the parameters of the selected input:
Enter the country, the channel number and offset (if the input selection is for channel);
• Flag the ENABLE checkbox to enable the receiver. Any unused inputs should be deactivated to save
energy;
• The receiver association to the input signal source. It's possibile to decide to link the inputs to the external
CONNECTOR or to the LOOP (in LOOP condition the RF signal is cascadable available from the previous
input);
• Selection of the reception frequency input mode (i.e. for RF channel or for frequency - MHz);
• Selection of the bandwidth and the frequency - MHz (if the input is selected by frequency);
• Select the installation country, the RF channel and the offset (if the input selection is for channel);
• Selection of the Input RF standard;
• Selection of the input channel priority;
• SAVE key to save the settings.
The right section shows information relevant to the multiplex locking status, the power/quality of the input
signal and other main informations relevant to the locked channel.
CLICK ON "SAVE" TO STORE THE DEFINITIVE CONFIGURATION.
5.2.1 DTT INPUTS CONFIGURATION
FIG. 3
44