Baby auto RÜCKKO plus Guide D'utilisation page 29

with the headrest) is at shoulder height on the child or slightly above, but never
behind the back or at ear level (fig. 6.2).
1. Put your hand on the headrest and push the lever upwards
seat down with your other hand to prevent it from moving (fig. 6.1). Adjust the
headrest on the right shoulder height for the child.
2. Loosen the harness straps by pulling them gently while pressing the harness
adjustment button
3. Release the harness buckle by pressing the red button (fig. 6.4) and put the
harness straps on both sides of the seat.
4. Place the child in the seat and fit the safety harness around the child.
5. Put together the 2 parts of the fastener (fig. 6.5).
6. Secure the child in the harness by joining the two parts of the clasp and
fastening the buckle (fig. 6.6) until you hear a click.
7. Gently pull the harness adjustment strap
8. Remember that in order to ensure the child's safety the harnesses should fit
tightly (fig. 6.8).
9. Make sure the belts are not twisted.
7. INSTALLING THE CHILD SEAT FORWARD FACING. GROUP 1
NOTIFICATION
For group 1 this car seat has 2 modes of installation. Although we advise to use the
seat backward facing to the travel direction for an up to 13 kg child, it is possible
to install the seat forward facing, if:
• The size of the vehicle does not allow safe installation of the seat backward facing.
• The size of the child exceeds the height percentiles and this causes the child to be
incorrectly positioned in the seat.
1. Remove the rebound bar
unlocking button (N).
(I)
(fig. 6.3)
Only for use with Group 1. From approx. 9
months to 4 years of age (9-18 kg)
(M)
from the isofix base by pressing the rebound bar
(J)
to achieve the correct tension (fig. 6.7).
(A) while holding the
29