Kenwood DNX571TR Guide De Démarrage Rapide page 17

Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1
3
5
(M5x6mm)
7
9
Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring harness.
4) Connect the wiring harness wires in the
following order;
ground, battery, ignition.
5) Connect the wiring harness connector to the
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Press the <Reset> button. (P.4)
9) Perform the Initial Setup.
See First Step (P.6).
2
(2 m)
x1
4
(3 m)
x2
6
(M5x7mm)
x6
8
(5 m)
x1
x1
⿠Non-Japanese cars
x1
x1
⿠Japanese cars
5 or 6
x6
x1
✎
NOTE
• Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (eg, the
sound may skip).
Ñ Trim plate
1) Attach accessory 7 to the unit.
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it
in place.
Car Bracket
7
English ñ
5 or 6
17