Kamikaze KV 3 Manuel D'utilisation page 72

ELECTRONIC TYING MACHINE
1. Open back cover.
2. Press feeding tray, rotate according to the direction of arrow.
3. Remove feeding tray.
4. Put in tying wire, note the winding direction of the wire.
5. Press feeding tray, rotate according to the direction of arrow to assemble it.
6. Holds wire head.
7. Pull out two tying wires tied beside with a tweezers.
8. Put in wire head from tail end, the direction of wire head shall be the same
as feeding tray, check that there is no knotted or twisted wire.
9. After confirming that wire is put in place, switch on battery, pull trigger; after
confirming that wire is guided into the tying machine, switch off battery.
10. After wire is guided into the tying machine, reconfirm if wire has any
twisted phenomenon at inlet, as shown in the figure.
11. After confirming that tying wire is installed correctly, close back cover.
12. Hold the grip, start working after switching on power.
13. After using up each roll of wire, timely clear up residual wire head.
14. In the process of tying, if tying is not successful, please use tweezers to
clear up residual wire timely, then continue working.
72
www.kamikazevolpi.com