Charging The Battery; Battery Charging Procedure - Kamikaze KV 3 Manuel D'utilisation

ELECTRONIC TYING MACHINE

10. CHARGING THE BATTERY

Don't dispose battery under high temperature or vibration
environment to avoid liquid leakage hurt body.
Disconnect the battery from tool before charging.
Always make sure the battery is dry and clean before charging.
• Make sure the battery is fully charged before first time using.
• The battery is not fully charged when you buy, you must charge 3-5 hours
before using first time.
• Re-charging battery when indicator shows one LED light.
• Do not charge batteries over 5 hours, don't use up completely otherwise
battery life will be reduced.
• Need to replace battery if battery running time is not enough. Users can
only use the original equipment manufactured by the customer center
(OEM) battery pack.
• Keep safety rules and environment protection information in mind all the time.

10.1 BATTERY CHARGING PROCEDURE

• Charge at temperature of + 10°C ~ + 22°C indoor.
• Make sure the switch at "OFF" position before charging.
• Connect adaptor of charger with battery correctly.
• Make sure specifications on battery and adapter matched before
charging.
• Red LED light on the charger indicates the battery is charging, green LED
light indicates fully charged, average charging time is about 4-5 hours.
• Pull out connector from power and battery after fully charged.
• Please make sure the battery charged at least once every 6 months when
the battery is not using.
69
www.kamikazevolpi.com