Sony PS-X60 Mode D'emploi page 9

@ Select the correct position of the Record Size/Manual Selector
according to the record size.
@ Push the POWER Switch.
© Select the correct record speed. When the power is turned
on, the 33 rpm is selected automatically.
@ Set the Cueing Lever to the © position.
@ Push the START/STOP Button. The Lamp will illuminate and
play will begin automatically.
eAfter the Tonearm has lowered onto the record, adjust the
volume and tone of the amplifier.
@When the Tonearm reaches the end of the record, it will auto-
matically rise and return to the Arm Rest. and the turntable will
stop.
Notes
e@Turn off the POWER Switch after the Tonearm returns fully
to the Arm Rest. If the POWER Switch is turned off while the
Tonearm is still moving in the return operation, the unit may not
start correctly the next time.
elf the Lamp goes out just after pushing the START/STOP
Button to start the Tonearm, it indicates that the unit had been
in the return mode when the power was cut off. In this case,
push the START/STOP Button again, and the Lamp will light up
and the Tonearm will start.
MANUAL PLAYING (TO START PLAYING PART-WAY ON THE
RECORD)
@ Set the Record Size/Manual Selector to the MANUAL position.
@ Push the POWER Switch.
@ Select the correct record speed.
@ Set the Cueing Lever to the © position.
@ Bring the Tonearm to the position you desire over the record.
@ Push the START/STOP Button. The turntable will start rotat-
ing, the Tonearm will lower itself, and play will begin.
@When the Tonearm reaches the end of the record, it will auto-
matically rise and return to the Arm Rest, and the turntable
will stop.
NOTES
elf you push the REPEAT Button in manual playing, the Repeat
Lamp will illuminate but the repeat function will not operate.
After playing, the Tonearm will return automatically to the Arm
Rest, but the turntable will continue rotating. In this case, push
the START/STOP Button to stop the turntable.
@ lf you bring the Tonearm too near the label of the record while
the turntable is rotating, the Tonearm may return to the Arm
Rest as a result of having activated the automatic return mecha-
nism.
TO STOP DURING PLAY
Push the START/STOP Button. The Lamp will go out, and the
Tonearm will return to the Arm Rest.
REPEAT PLAYING
In automatic playing, repeat function is possible. Push the RE-
PEAT Button. The Repeat Lamp will illuminate and the unit
will repeat the same record.
To stop repeat playing, push the REPEAT Button again. The
Repeat Lamp will go out, and after the record is played, the
Tonearm will return to the Arm Rest.
CUEING LEVER
Usually, keep the lever in the y position. To lift up the stylus
orto change the listening point during playing, set the Cueing
Lever to the vw position. The Tonearm will rise. To start play-
ing again, lower the Cueing Lever toward you.
STROBOSCOPE AND NEON LAMP
a eae i)
TIPS ON RECORD HANDLING
Before playing
When record playing
eWhile the turntable is energized, don't attempt to stop or
reverse the turntable by hand.
e@During play, be sure to close the dust cover.
anything on the dust cover.
e@While playing, never attempt to move the turntable or touch
the tonearm.
Don't place
After playing
e@ Avoid exposing records to any source of heat, such as ¢ rect
sunlight, a hot-air duct, etc. Store records vertically without ap-
plying any pressure or inclining to either side. This will mininnize
any warpage.
@When not using the turntable, close the dust cover.
Other precautions
@Don't put anything but records on a turntable.
@Don't place anything but the spare cartridges and 45epm
adaptor on the turntable deck.