Publicité
Les langues disponibles
Les langues disponibles
TONEARM
DROP-POINT
ADJUSTMENT
At the
factory,
the
tonearm
has
been
adjusted
to
have
the
correct drop point in the automatic
playing
mode.
lf this needs to be readjusted,
proceed
as follows.
@ Remove the rubber cap of the tonearm
drop-point
adjustment
hole located
at the left side of the arm
base.
@ Insert the supplied drop-point
adjustment
key into the hole.
To change
the
drop
point
inward...
Turn the screw slightly
counterclockwise.
To
change
the drop-point outward...
Turn the screw slightly
clockwise.
e@Once
it is properly adjusted with
a 30cm
(12")
record,
the
drop point will be correct for 17 cm (7") and 25cm (10") records
as well.
REPACKING
FOR
SHIPMENT
The original shipping
carton
and
packing
material
(which
we
asked
you to save) are the
ideal
container for use
in shipping
the unit for repair work, or to another
location.
To secure the
maximum
protection,
it must
be repacked
in this material
pre-
cisely as before.
The proper
repacking
procedure
is shown
in
the illustration.
@Clip the tonearm
to the
arm
rest
and
bind
it there
with
a
tape.
e@Fasten
the transit screws in their original position by referring
to the
illustration
of "TURNTABLE
ASSEMBLY"
to secure
the
inside parts to the cabinet.
Turn the screws
fully clockwise.
MAINTENANCE
@Clean the cabinet and dust cover periodically with a soft dry
cloth.
Do not use solvents such as alcohol, benzine or thinner,
since they will damage
the finish.
@ When
the rubber
mat becomes
dirty, wipe
it gently
with
a
soft cloth slightly dampened
with water.
@WNo lubrication is required for this turntable.
The
motor shaft
is factory lubricated for the life of the turntable.
Publicité
