Sony PS-X60 Mode D'emploi page 6

TONEARM ASSEMBLY AND ADJUSTMENT
ments.
When a Cartridge is replaced, readjustments are required.
Preparation
@ Remove the stylus guard, if fitted.
[i Arm Rest
Koo"
: Extra weight
t=
Sy =
3
Counterweight
Cueing Lever
Longitudinal balance adjustment *1
For this adjustment, connect the power cord and turn on the
POWER Switch.
@ Set the Record Size/Manual Selector to the MANUAL position.
@ Push the START/STOP Button. The turntable will start rota-
ting. After several rotations of the turntable, turn off the POWER
Switch and at the same time stop the turntable by hand; do
not turn off the START/STOP Switch. This will cause the Tone-
arm Platform to lower and permit a more positive longitudinal
balance adjustment.
@ Be sure that the Anti-skating Compensator is at "O".
@ Release the Tonearm from the Arm Rest and set the Arm
Rest as illustrated.
Anti-skating
compensator
"oO"
@ Turn the Counterweight as required until the Tonearm is in
a horizontally balanced position. (The Tracking-force Ring turns
simultaneously.)
Release your fingers and check
the balance. Repeat this step
until the arm balances.
Pee Correct balance
mm
@ While holding the Counterweight at the balanced position,
separately turn the Tracking-force Ring until the "O" indication
meets the center line on the Tonearm. Recheck the balance.
Center line
Do not move
the counterweight.
Tracking-force Ring
@ Pull up the Arm Rest and turn it counterclockwise so that
the Arm Rest returns to its original position. Secure the Tone-
arm to the Arm Rest again.
Tracking-force adjustment *2
Turn the Counterweight counterclockwise so that the recom-
mended tracking-force figure for your cartridge is aligned with
the center line on the Tonearm. The maximum tracking force
available is 2.5 grams.
Tracking-force ring will
turn at the same time.