Further Dab+ Information; Dab+ Menu Functions; Using The Fm Radio; Setting Fm Stations - Kenwood CR-M10DAB Notice D'emploi

Further DAB+ information

With DAB+, additional information is also transmitted in addition to music signals. This can be
brought up as follows.
Press the <INFO> button to successively call up the following information:
• Signal level: This is shown by symbols appearing in the display from left to right.
The more symbols are shown, the better the reception.
• PTY (Programme Type): This indicates the division of the stations into categories, e.g. pop, news,
religion, info. classics, etc. Name of the ensemble, e.g. "DR Deutschland"
• Displaying the channel and frequency of the set station
• ERR XX: This information shows the error rate of the digital reception. This is also dependent on the
signal level and is also used for adjusting the aerial.
• XX K BPS: This displays the station's data rate, e.g. 80 kBit/s. The data rate can differ from station
to station.
• DAB+: Denotes the 'DAB+' reception type
• Current time
• Current date

DAB+ menu functions

The <MENU> button opens a menu in which different functions for DAB+ can be set. The menu can be
scrolled through using the <TUNE+-> buttons. The following functions can be set:
• Full scan: Renewed automatic station scan. Confirm the function by using the <VOL> button.
• Manual tune: Use this to set a particular reception channel manually.
• The function is confirmed using the "VOL" button and the currently set channel is shown in the display with its
associated frequency.
• Press the <Tune+-> buttons to manually select another channel.
• Confirm the selection using the "VOL" button. The signal level will then appear in the display. Press
the button again to load the current ensemble.
• DRC (Dynamic Range Control): Provided this is support by the set station,
an adjustment can be made to the dynamic range. Possible settings are "Off", "Low" and "High".
Selection is made using the <Tune+-> buttons and the selection is confirmed using the <Vol> button.
• Prune: This function deletes invalid stations from the station list. Select using the
<VOL> button, select "Yes / No" using the <TUNE+-> buttons and confirm with <VOL>.
• SYSTEM: Settings for sleep timer, alarm, time, language and factory settings

Using the FM radio

Press the <SOURCE> button until "FM"appears in the display.
Setting a FM station
• Press the <TUNE +> button to increase the reception frequency.
• Press the <TUNE -> button to decrease the reception frequency.
• If you hold down the <TUNE +> or < TUNE - > buttons, an automatic station scan starts
which will stop at the next detected station.
• If you press and hold the <AUTO/ENTER> button for a few seconds, the automatic Station search
starts. All found stations are stored.
12