Before Switching On The Power Supply - Kenwood CR-M10DAB Notice D'emploi

Before switching on the power supply

IMPORTANT SAFETY INSTRUCTIONS
Attention: Please read this page through carefully to ensure safe operation of this device.
Read the instructions carefully!
- Please follow all safety and operating instructions when putting this product into operation.
Keep the instructions in a safe place!
- You should retain the safety and operating instructions for later reference.
Please observe the warning signs!
- You should rigorously follow all the warnings indicated on the product and specified in the
operating instructions.
1. Clean with a dry cloth only!
- Remove the plug-in power supply of this device before cleaning this product. Never use liquid
cleaning agents or cleaning sprays. Use a dampened cloth only for cleaning.
2. Accessories
- Only use the accessories indicated by the manufacturer.
3. Do not use this device near water
- The device should never be exposed to water droplets or water sprays - as would occur for
Never place a container filled with liquid, such as a vase of flowers, on the device.
4. Ventilation
- Slits and openings in the device are used for ventilating the device to ensure reliable operation of
the device and to protect the device from overheating and potential spontaneous combustion. Do
not block the ventilation openings. Install the device according to the manufacturer's instructions.
Never block the ventilation openings, for example, by placing the device on a bed, sofa, rug or similar
soft underlay. The device should not be built in to a bookcase or fitted furniture unless adequate
ventilation has been assured.
5. Power supply
- This device may only be connected to the mains supply using the plug-in power supply unit provid-
ed. Use this adapter for the Compact Radio CR-M10DAB only. In any case ensure that the local mains
supply corresponds to the specifications on the plug-in power supply unit. If you are not sure about
the type of voltage supplied to your home, contact your dealer or the local energy supply company.
6. Plug-in power supply unit
- Take care to prevent the possibility of tripping over the cable or that it is disconnected in the im-
mediate vicinity of a socket, including additional sockets. The cable may also on no account become
crimped when leaving the plug-in power supply.
7. Thunderstorms
- Disconnect the device in the event of thunderstorms and if unused for an extended period.
8. Overloading
- Never overload the mains socket, extension cable or power strip, because otherwise there is a risk
of fire or electrical shock.
9. Ingress of foreign material and liquids
- Take care that foreign material or liquids never enter into this device through the ventilation open-
ings, since otherwise contact to high-voltage live components or a short circuit with the resulting fire
3