HP Designjet 130 Guide De Référence Rapide page 19

HP Designjet 130/130nr Printer - Quick Reference Guide
How Do I Replace Printheads?
If one of the printhead icons on the front panel (see page 39) is flashing, the
corresponding printhead has failed or needs attention. Check that the printhead
is properly seated, and clean the printhead contacts (see page 14). If the
problem persists, replace the printhead.
1. Open the front hinged flap at the right of the printer.
2. Open the second (back) part of the flap and lift it back fully. The print
carriage will move to the left and then back to the right. Wait for it to stop.
3. Pull the printhead cover up and towards you, so that the hook at the front
unlatches itself, and then push the whole cover back so that the printheads
are exposed.
4. For each printhead that needs to be replaced:
• Lift the small handle at the top front and use it to pull the printhead vertically
up and out of the printer.
• Take the new printhead and remove the tape that protects its electrical
contacts and ink nozzles.
...continued on next page...
17