Table des Matières
Publicité
7
7
Check-out our assembly video
on cornilleau.com
The blue dots on the jumping mat indicate the
starting point for this step. To prepare the jumping
mat before to be attached to the frame, you must
first pass the steel hooks through the meshing as
shown above. (each hook must connect 3 loops).
10
8
8
8
In order to attach the hooks securely, use the loading
power tool and wear gloves to protect your hands.
WARNING: Trampoline is under heavy tension, more
effort may be required to attach the hooks to the
frame.
13
Gradually attach one by one the hooks of the frame.
16
5
Tie all black straps under safety pad to the frame as
shown above .
fr.cornilleau.com
8
This step takes approximately 30 to 45 min
Each hook must categoricaly follow one another and
every single loop needs to be connected to a hook.
11
A
8
Attach the steel hooks to the frame. Start from a foot
and a blue dot (point A and B).
14
Congratulations ! You have done the tough part.
Hang on, you're almost there ; )
17
12
Assemble the safety enclosure pole sets using the
locking pin. (The top section is pre-assembled with
the fixing end (12) while the lower parts is curved with
a slight kink at the bottom).
17
9
7
Both ends of the mesh overlap, hence the last hook
must go through six loops in order to connect them.
12
B
A
Continue to attach the hooks on the frame as follow:
- a quarter to the right of point A
- a quarter to the left of point B
- Finalize the two remaining quarters
15
Lay the safety pad around the jumping mat with
the flaps raised up. Make sure to align each section
with a T-tube connector and that the safety label is
correctly located at the entrance of the safety net.
18
10
Encase the safety enclosure poles in the PVC sleeves
leaving the fixing end for the upper hoop exposed.
EN
7
D
B
C
8
5
12
10
11
www.cornilleau.com
Publicité
Table des Matières
