Hansgrohe AXOR Bouroullec 19670401 Instructions De Montage / Mode D'emploi / Garantie page 8

3
⅜" / 10 mm
4
5
8
3
2
1
10 mm
English
Drill the screw holes.
Install the anchors.
Seal the wall around the anchors using waterproof
sealant.
Failure to seal the wall may lead to
water damage.
Wrap the threads on the nipples using Teflon tape.
Install the threaded connections on the nipples.
Tighten them using a 10 mm Allen wrench (not
included).
The connections should extend 1⅝" – 1¾" outside
the surface of the finished wall.
Seal the wall around the nipples using waterproof
sealant.
Failure to seal the wall may lead to
water damage.
If the nipples are slightly too close together, or are
slightly too far apart, remove the knockouts from the
mounting plate.